This integrated electric distribution panel (load center) simplifies your rig’s electrical system and saves space by combining circuit protection for both your 12-volt DC loads (with blade fuses) and your 120-volt AC loads (with circuit breakers).
Can be configured as for either 30 amp or 50 amp main service
Panel mounted with a black finish and fold-down access door.

The 120 volt AC side it can be configured for either 30 amp service and uses standard residential circuit breakers. When used with dual-leg (240-volt) power, the WF-8930/50NP has spaces for two 50 amp (or 30 amp) main breakers and up to 12 branch circuit breakers (when using tandem breakers). When used with single-leg (120-volt) power, there is space for one 50 amp (or 30 amp) main breaker and up to 6 branch circuits (when using tandem breakers). For a list of factory-tested and approved breakers can be found in the manual. You can also find breakers we've used in this Google Sheet of products we recommend but don't sell (yet)!

The 12 volt DC side supports up to 15 circuits (fuses). Each of the circuits has a small red LED light that indicates a blown fuse.

Outer Dimensions: 13 3/4" wide x 9 1/2" tall x 4" deep
Rough Opening: 12 3/16" wide x 8 3/16" tall x 3" deep
Weight: 3.75 pounds

PDF Brochure
PDF Manual

Important: This panel is not ignition-protected, and should not be installed in a compartment with batteries or any LP gas.

Other Features of the WFCO WF-8930 Electric Panel

Built-in standard protection for over-current, over-temperature, over-voltage, reverse polarity
Two-piece, includes door with window
Built-in terminal bars for negative DC wiring
Built-in strain reliefs in cabinet back (suitable for 10/2-14/2 Romex)
Rear-mounted AC 15A or 20A receptacle, allowing easy converter plug-in for power
UL and cUL listed
Limited 2-year warranty.

Collection: WFCO

WFCO WF-8930 Combo 120-Volt AC and 12-Volt DC Load Center

Save $20 on Your First Order

Builder & Installer Directory

Search