3M 540 Sealant (White)

Fuse Holder

The 12/24-volt version of the kit comes with a Victron Energy mega fuse holder while the 48-volt version comes with a Victron Energy MIDI fuse holder that is rated up to 58-volts.

Fuse 

The 12-volt version of the kit comes with a Victron Energy 125 amp mega fuse, the 24-volt version comes with a Victron Energy 60 amp mega fuse and the 48-volt version comes with a Victron Energy 30 amp MIDI fuse that is rated up to 58-volts.

Wire

The 12-volt version of the kit comes with 25′ of red and black 2 AWG wire, the 24-volt kit comes with 25′ of red and black 4 AWG wire, and the 48-volt version comes with 25′ of red and black 8 AWG wire.  For comparison, the Nomadic Cooling “DIY Install Kit” includes approximately 15′ of wire in their 12/24-volt kit and approximately 11′ of wire in their 48-volt kit.

Splicers

2x appropriately sized splicers. There are short, power supply wires that come off the Nomadic AC unit with connectors (large Anderson-style connector on the 12/24-volt units and ring terminals on the 48-volt units) that you’ll cut off and then use these splicers to bridge your branch circuit wiring to the supply wires on the AC itself. The splicers should then be covered with heat shrink which is also provided to secure and protect the splice.

Lugs & Heat Shrink

12-volt kit

• 1x – 2 AWG, 5/16″ lug – positive bus bar connection
• 1x – 2 AWG, 5/16″ lug – negative bus bar connection
• 1x – 2 AWG, 5/16″ lug – positive input side of mega fuse holder
• 1x – 2 AWG, 5/16″ lug – positive output side of mega fuse holder
• Heat shrink for the 2x splicers, heat shrink for each lug

24-volt kit

• 1x – 4 AWG, 5/16″ lug – positive bus bar connection
• 1x – 4 AWG, 5/16″ lug – negative bus bar connection
• 1x – 4 AWG, 5/16″ lug – positive input side of mega fuse holder
• 1x – 4 AWG, 5/16″ lug – positive output side of mega fuse holder
• Heat shrink for the 2x splicers, heat shrink for each lug

48-volt kit

• 1x – 8 AWG, 5/16″ lug – positive bus bar connection
• 1x – 8 AWG, 5/16″ lug – negative bus bar connection
• 1x – 8 AWG, #10 lug – positive input side of MIDI fuse holder
• 1x – 8 AWG, #10 lug – positive output side of MIDI fuse holder
• Heat shrink for the 2x splicers, heat shrink for each lug